Ben Groves
- Total activity 28
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 13
Activity overview
Latest activity by Ben Groves-
Ben Groves created an article,
Connect a Generic Modbus TCP Device
🧾 OverviewThis guide walks you through the steps to connect any generic Modbus TCP device to MachineMetrics using a custom adapter script. You’ll define register mappings in YAML, apply Modbus addr...
-
Ben Groves created an article,
How to Find Rapid Dial Address on a Fanuc CNC.
1 Prepare the Machine & Work AreaSafe state – Put the machine in MDI or “zero-feed” mode, spindle stopped, and ensure no axes will move when you twist the dial.Visual access – Swing the control so ...
-
Ben Groves created an article,
Sealevel 170POE — IP Configuration & Factory Reset Guide
 Table of Contents Overview Before You Start Method A – Direct Static Configuration Method B – Enable DHCP Factory Reset Options Troubleshooting Appendix A – LED Cheat‑Sheet  Ov...
-
Ben Groves created an article,
Sealevel 170POE Overview
 Table of Contents Overview Hardware Limits & Recommendations Analog Inputs Optically‑Isolated Digital Inputs Power Options & PoE Wiring Examples Current Transducer → Analog Input...
-
Ben Groves created an article,
Production Analytics Guide
Understand, Improve, and Profit from Every Run MachineMetrics’ Production Analytics module gives manufacturers a powerful lens into production performance by combining real-time machine data with E...
-
Ben Groves created an article,
Connecting a CLICK PLC to MachineMetrics via Modbus TCP
This guide helps you connect a CLICK PLC with Modbus TCP/IP support to MachineMetrics for real-time machine monitoring. It includes compatible models, signal requirements, configuration instruction...
-
Ben Groves created an article,
Brother D Series CNC: Ethernet & OPC UA Setup Guide
This step-by-step guide explains how to configure Ethernet settings, assign a static IP address, enable OPC UA, and save your settings on a Brother D Series CNC machine. It includes important notes...
-
Ben Groves created an article,
How to Enable Parameter Write Enable (PWE) on a Fanuc CNC
⚠️ Important Safety Notice This procedure should only be carried out by qualified maintenance personnel. MachineMetrics takes no responsibility for any errors, damage, or unintended behavior resul...
-
Ben Groves created an article,
Connecting to Mazak without MTConnect
Overview There is an application on the Mazak control called Fusion Client. It was developed by Mazak to output UDP packet information to their CyberMonitor Tower system on Windows based controls. ...
-
Ben Groves created an article,
Haas Part Counter
Default - Single Cycle By default a Haas CNC will part count when it reaches M30. This is most common on milling machines or single spindle lathes. Â Continuous Looping Programs with M99 Where prog...