Introduction
MachineMetrics has a proprietary MTConnect adapter available for Mitsubishi M7/700 series controls. All Citizens with a Mitsubishi M7/700 control support the MachineMetrics MTConnect Adapter.
Topics covered in this article
- Mitsubishi NCU Required Firmware Upgrades
- Control Configuration
- How to enable part count in single mode on Citizen M700 series controls
Mitsubishi NCU Required Firmware Upgrades
Before configuring your control for communication with MachineMetrics, please contact your Citizen machine vendor and request that your Mitsubishi NCU firmware be updated to the latest version. This will ensure that MachineMetrics can access control data from the machine without system freezes or interruption.
Once you have confirmed that your firmware is up to date, communicate with your Customer Success Manager to ensure your gateway meets the proper requirements. Once you have spoken with your CSM, you can proceed in configuring your M& for communication.
Control Configuration
Here's a Video overview on how to configure a Citizen M700 for communication:
-
Press “MAINT” hardkey.
-
Press “I/F DIAG” softkey.
-
Type in “1001//M” and hit “INPUT” softkey.
-
Press “PARAM” hardkey.
-
Press “MENU SEL” softkey once.
-
Press “BAS COM” softkey.
-
“Press PGDN” hardkey until you see “Global IP Address”.
-
WARNING: DO NOT ENTER IPs INTO “HMI IP” FIELDS, THIS WILL BRICK YOUR MACHINE!
-
Enter desired IP, SUBNET MASK, and GATEWAY IP.
-
Press “INPUT” Hardkey after each entry.
-
Reboot machine for settings to take effect.
-
Ping IP to test communication.
How to enable part count in single mode on Citizen M700 series controls
-
Press the MAINT hard key.
-
Press the I/F diag soft key.
-
Type 1001//M then Press INPUT.
-
Press the PARAM hard key.
-
Scroll to the right with the arrow keys until you see Menu Sel
-
Press the Menu Sel soft key.
-
Press the BIT SELECT soft key.
-
Select parameter 6401.
-
Change the third from the right number from 0 to 1. (Ex. 01001000 -> 01001100).
-
Press the INPUT hard key.
-
Reboot the machine.
Comments
0 comments
Please sign in to leave a comment.